Aladdin Paraffin Heater Wick - For Models 201 & 202

Aladdin Paraffin Heater Wick - For Models 201 & 202

• Paraffin heater wick
• For models 201 & 202
• Part no: 939907

• Use only genuine Aladdin Wicks, as using other wicks may result in poor performance and cause problems for which Aladdin cannot be responible.

To fit the new wick:

• Remove burner from tank.
• Take out flame spreader.
• Remove outer wick tube by turning anti-clockwise and lifting.
• Turn wick up fully and pull it out of burner with wick carrier.
• Pass paper tabs on new wick through the two semi-circular slots in burner base. Pull tabs until bottom of tape isnside wick is just below top edge of centre tube.
• With arms uppermost fit carrier to burner on winder side so that the rack slides over guide inside large tube.
• Push carrier down until rack just engages with winder cog. Ensure that they are properly engaged, then turn down wick.
• Pull tails of wick evenly so that wick carrier rack engages with wick winder mechanism inside large tube. Turn down wick as far as possible.
• Replace flame spreader (holes uppermost).
• Replace outer wick tube by locking it under all three pips inside rim of burner.
• Tear paper tabs from wick. Replace burner in tank. Fill container with paraffin and allow the new wick to soak for at least one hour before lighting.