Aladdin 13 Valmin Heater Wick - For Valor Convector Heaters

Aladdin 13 Valmin Heater Wick - For Valor Convector Heaters

• Aladdin Valmin heater wick
• For Valor convector heaters
• Part no: 13

• Use only genuine Aladdin Wicks, as using other wicks may result in poor performance and cause problems for which Aladdin cannot be responible.

Suitable for use in the following Valor Heaters:

• 100, 200, 300
• L12, L20, L30, L32, L37, L38, L50, L60, L207, L210
• Module 1, 2 & 3, Modulette 1 & 2, Valorvector 1 & 2, Valorvector 1 & 2, Valormatic, Viceroy, Vulcan, Viking etc.

To Fit:

• Remove flamespreader
• Unscrew and remove gallery with sealing washer
• Turn old wick up as far as it will go and pull right out of reservoir
• Take new wick and place split end over central draught tube
• Line up slots on rack with cog wheel and push down to engage
• Turn down wick, easing the wick lining tape over the central draught tube, using fingernail or table knife
• Replace gallery sealing washer, gallery and flamespreader
• Allow wick to soak for one hour before lighting